 Quadruple male connector for a cross junction. The two stop "arms" instert into predrilled holes and can be swung either way to allow the train to pass.
|
 Quadruple male junction rotator. One side shows the junction taken apart and the other is assembled. The center piece rotates 360 degrees.
|
 Large multi cross splitter, with 4 female couplers. You can add 2 bridges and build a second tier of track.
|
 Small multi cross splitter, with 4 female couplers. You can add 2 bridges and build a second tier of track.
|
 Straight Pieces. Three different sizes. 8 1/2", 5 7/16" and 4 1/4" long. Track is cut out one one side only.
|
 Larged curved "Y" track. Track is cut out on both sides and can be turned over.
|
 Small curved "Y" track. Track is cut out on one side and can not be turned over.
|
 Small curved track. It takes 8 pieces to complete one circle. Track is cut out on both sides and can be turned over.
|
 Large curved track. It takes 8 pieces to complete one circle. Track is cut out on both sides and can be turned over.
|
 Cross Piece. Right angled junction. Track is cut out on one side only.
|
 The bridge comes in three pieces. The top straight piece is a double female piece. The off ramps are both double female. Use two sets of bridges plus a multi cross and you get a raise junction.
|
 Small track pieces each measure 2 inches long. Shown here is a double male, used to join two track boards together, a female run off, a regular small, a male run off and a double female piece.
|
$
P
R
I
C
E
S
|
Large curved track. It takes 8 pieces to complete one circle. Track is cut out on both sides and can be turned over.
Cross Piece. Right angled junction. Track is cut out on one side only.
The bridge comes in three pieces. The top straight piece is a double female piece. The off ramps are both double female. Use two sets of bridges plus a multi cross and you get a raise junction.